Campbell-scientific AP200 CO2/H2O Atmospheric Profile System Manual de usuario Pagina 39

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 38
AP200 CO
2
/H
2
O Atmospheric Profile System
FIGURE 5-9. H
2
O span inlet configured for a dewpoint generator
5.3 Wiring
5.3.1 Ground Connection
The AP200 must be earth grounded. Refer to section 7.1, ESD Protection in
the CR1000 Measurement and Control System Operator’s Manual, for
information on earth grounding and lightning protection. All component
grounds of the AP200 profile system are pre-wired at the factory to a common
ground lug located at the bottom of the enclosure. Ground this lug using
heavy-gauge copper wire. An AP200 grounded to the UT30 tower is shown in
FIGURE 5-10.
FIGURE 5-10. AP200 earth grounded on a UT30 tower
27
Vista de pagina 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 119 120

Comentarios a estos manuales

Sin comentarios