Campbell-scientific AP200 CO2/H2O Atmospheric Profile System Manual de usuario Pagina 38
- Pagina / 120
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
AP200 CO
2
/H
2
O Atmospheric Profile System
FIGURE 5-8. AP200 system enclosure configured with cylinders of
zero air and CO
2
Flow meters and needle valves are not needed because the
AP200 zero and span inlets have flow restriction inside the
system enclosure to set the flow rate.
Make sure there are no leaks in the regulators or the connections
to the valve module. For automatic operation, the tank shutoff
valves are left continuously open. A plumbing leak could cause
the contents of the tank to be lost.
When inlets are not in use, replace the Swagelok
®
plug to keep
the system clean.
Open the shut-off valves on the cylinders and set the pressure regulators for 0-
psig delivery pressure.
If the pressure is inadvertently adjusted to high, the tube fitting
may need to be slightly loosened to bleed off the excess pressure.
Retighten the fitting when the proper setting is reached.
5.2.3 H
2
O Span
The H
2
O span can be performed only as a manual operation. Automated H
2
O
span is not feasible because it would require a dewpoint generator to provide
the H
2
O span gas all the time. The H
2
O span inlet is not bypass equipped, so it
will flow only when selected. This inlet can be connected to the output of a
dewpoint generator using a tee at the inlet, as shown in FIGURE 5-9, to bleed
off excess flow and avoid pressurizing the dewpoint generator.
NOTE
NOTE
26
- INSTRUCTION MANUAL 1
- Limited Warranty 3
- Assistance 4
- Precautions 5
- Figures 9
- Table of Contents 12
- AP200 CO 13
- O Atmospheric Profile 13
- 3. Initial Inspection 14
- 4. Overview 14
- 4.1.2 Optional Components 16
- 4.1.3 Common Accessories 18
- 4.1.4 Other Accessories 21
- 4.1.5 Support Software 21
- 4.1.6 Replacement Parts 22
- 4.2 Theory of Operation 23
- 4.2.1 Intake Assemblies 25
- Ambient Pressure (kPa) 26
- 4.2.2 Valve Manifold 27
- 4.2.3 Pump Module 28
- 4.3 Specifications 30
- 5. Installation 32
- 5.1.2 AP200 Enclosure 33
- 5.1.3 Intake Assemblies 33
- 5.2 Plumbing 35
- 5.2.2 Zero and CO 37
- 5.2.3 H 38
- 5.3 Wiring 39
- 5.3.2 Intake Heater Cables 40
- 5.3.3 Power 44
- 5.4 Configure the Program 46
- 5.4.2 Compile Switches 49
- 5.6 Verify Performance 50
- 5.6.3 On-site System Checks 51
- 6.1 Automatic Zero and Span 52
- 6.2 Manual Zero and Span 53
- 6.2.2 Do CO 54
- 6.2.3 Do CO 55
- 6.2.4 Do H 56
- 7.1 Plumbing Leaks 58
- 7.2 Enclosure Desiccant 59
- 7.3 Intake Filters 59
- 7.4 LI-840A (IRGA) 62
- 7.4.2 Configuring the IRGA 63
- 7.5 Zero/Span Flow 64
- 8. Repair 65
- CONFIG CO2_SPAN_PPM ppm CO 79
- Appendix D. Output Tables 81
- Appendix H. Using Swagelok 105
- Fittings 105
- Back ferrule 107
- Front ferrule 107
- Pf 101046.30007.1 111
- J.1 Introduction 113
- J.2 Removal 113
- J.3 Installation 116
Relacionado con productos y manuales para Instrumentos de medición Campbell-scientific AP200 CO2/H2O Atmospheric Profile System
Instrumentos de medición Campbell-scientific Bowen Ratio Instrumentation Manual de usuario
(36 paginas)
(36 paginas)
Instrumentos de medición Campbell-scientific CHP1 Pyrheliometer (from Kipp & Zonen) Manual de usuario
(23 paginas)
(23 paginas)
Instrumentos de medición Campbell-scientific CDM-VW300 Series Dynamic Vibrating-Wire Analyzer S Manual de usuario
(122 paginas)
(122 paginas)
Instrumentos de medición Campbell-scientific CM3 Kipp and Zonen Pyranometer Manual de usuario
(16 paginas)
(16 paginas)
Instrumentos de medición Campbell-scientific CMP6-L, CMP11-L, and CMP21-L Pyranometers Manual de usuario
(42 paginas)
(42 paginas)
Instrumentos de medición Campbell-scientific CM6/CM10 Tripod Weather Station Installation Manual de usuario
(68 paginas)
(68 paginas)
Instrumentos de medición Campbell-scientific CPEC200's EC155 Gas Analyzer's Packing I Manual de usuario
(1 paginas)
(1 paginas)
Instrumentos de medición Campbell-scientific CR10TCR Thermocouple Reference Manual de usuario
(10 paginas)
(10 paginas)
Instrumentos de medición Campbell-scientific CPEC200 Quickstart Guide Manual de usuario
(16 paginas)
(16 paginas)
Instrumentos de medición Campbell-scientific CR10XTCR Thermocouple Reference Manual de usuario
(12 paginas)
(12 paginas)
Instrumentos de medición Campbell-scientific CPEC200 Closed-Path Eddy-Covariance System Manual de usuario
(112 paginas)
(112 paginas)
Instrumentos de medición Campbell-scientific CR200/CR200X-series Dataloggers Manual de usuario
(208 paginas)
(208 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.088 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales