Campbell-scientific CR800 and CR850 Measurement and Control Systems Manual de usuario descargar pdf (Pagina 424)

100

101

Section 10. Troubleshooting

424



Figure 129: DevConfig terminal emulator tab

10.6.1 Serial Talk Through and Sniffer

In the P: Serial Talk Through and W: Serial Comms Sniffer modes, the

timeout can be changed from the default of 40 seconds to any value ranging from

1 to 86400 seconds (86400 seconds = 1 day).

When using options P or W in a terminal session, consider the following:

1. Concurrent terminal sessions are not allowed by the CR800.

2. Opening a new terminal session will close the current terminal session.

3. The CR800 will attempt to enter a terminal session when it receives non-

PakBus characters on the nine-pin RS-232 port or CS I/O port, unless the port

is first opened with the SerialOpen() command.

If the CR800 attempts to enter a terminal session on the nine-pin RS-232 port or

CS I/O port because of an incoming non-PakBus character, and that port was not

opened using the SerialOpen() command, any currently running terminal

function, including the communication sniffer, will immediately stop. So, in

programs that frequently open and close a serial port, the probability is higher that

a non-PakBus character will arrive at the closed serial port, thus closing an

existing talk-through or sniffer session.



1 2 ... 419 420 421 422 423 424 425 426 427 428 429 ... 565 566

Comentarios a estos manuales

Sin comentarios

Campbell-scientific CR800 and CR850 Measurement and Control Systems Manual de usuario Pagina 424

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Campbell-scientific CR800 and CR850 Measurement and Control Systems