Campbell-scientific NL240 Wireless Network Link Interface Manual de usuario descargar pdf (Pagina 14)

NL240 Wireless Network Link Interface

3.3 LoggerNet Setup

The next step is to run LoggerNet and configure it to connect to the datalogger

via the NL240.

• In the LoggerNet Setup screen, press Add Root and choose IPPort. Input

the NL240 IP address and port number. The IP address and port number

are input on the same line separated by a colon. IPv6 addresses will need

to be enclosed in square brackets when specifying a port number. An

IPv4 address may look like 192.168.1.100:6785. An IPv6 address may

look like [2001:db8::1234:5678]:6785. A fully qualified host name entry

may look like yourlogger.com:6785.

• Add a PakBus® Port (PakBusPort).

• Add a PakBus® Router (pbRouter). Input the PakBus address of the

NL240. The NL240 default PakBus address is 678.

• Add the datalogger and input the PakBus® address of the datalogger.

• Press Apply to save the changes.

• You can verify that your settings are correct by selecting the datalogger in

the Network Map, selecting the Clock tab, and pressing Check Clocks. If

your settings are correct, you should see the current clock of your server

and datalogger.

FIGURE 3-2. LoggerNet setup

3.4 Connect

You are now ready to connect to your datalogger using the LoggerNet Connect

screen.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Sin comentarios

Campbell-scientific NL240 Wireless Network Link Interface Manual de usuario Pagina 14