Campbell-scientific NL240 Wireless Network Link Interface Manual de usuario descargar pdf (Pagina 13)

NL240 Wireless Network Link Interface

• Ensure the NL240 is powered.

• Connect the supplied USB cable between a USB port on your computer

and the USB port on the NL240.

• Open DevConfig.

• Under Device Type, select Network Peripheral | NL240.

• Click the Browse button next to Communication Port.

• Select the virtual com port labeled NL240.

• Click OK.

• Click Connect.

• Click on the Wi-Fi tab.

• By default, the NL240 will attempt to connect to the strongest, unsecured

network available. This network will be shown in the Status field. If this

is not the network you wish to connect to, press the browse button next to

the SSID field. A dialog box showing all of the available wireless

networks will be displayed. Select the network you wish to connect to and

click OK. If this is a secured network, enter the password in the

Password field.

• Click on the NL240 tab.

• To enter a static IP address, select disable in the Use DHCP field. Then

input the IP Address, Network Mask, and Default Gateway. These

values can be provided by your network administrator.

• If a dynamic address is to be used, the network information acquired via

DHCP can be seen on the NL240 tab. (Note that if you have selected a

different network than the default network, you will need to press Apply

to save this change, then press the Connect button to reconnect to the

NL240 and view the network information.)

• Click Apply to save your changes.

It is recommended that a static IP address be given to the NL240

for most applications so that the path to the device is always

known. If using a dynamic IP address acquired via DHCP, you

may wish to configure the NL240 as a PakBus/TCP client.

NOTE

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Sin comentarios

Campbell-scientific NL240 Wireless Network Link Interface Manual de usuario Pagina 13