
CS125 Present Weather Sensor
28
14.1 The SET command
The set command is used to configure the CS125 via the command line. The SET
command is a single space delimited string that can be sent from any data logger
or PC equipped with an RS232 or RS485 port. The SET command and the
‘Device Configuration Utility’ software access identical settings within the
CS125, please refer to the ‘Device Configuration Utility’ section of this document
for a more detailed breakdown of the setting available here. This command is used
to change the default power up state of the sensor. See Section 14.2 if a setting is
going to be changed on a regular basis e.g. heater controls.
See Section 12 for more information on the values used by the `SET’ command.
Address based on Sensor ID
Sensor serial number (read only)
Polling Or Continuous modes
Message Format (Basic/Partial/Full)
RS232 or RS485 serial communications enabled
Dirty window compensation
CRC checking on received commands
Sensor power down voltage
Relative humidity threshold
Checksum (use the valid CCITT checksum)
(1) These values are shown in hexadecimal format not ASCII.
(2) As entered on a keypad.
Comentarios a estos manuales