Campbell-scientific RAWS-P Remote Automated Weather Station Manual de usuario descargar pdf (Pagina 26)

RAWS-P Remote Automated Weather Station

5.4.3 Troubleshooting

If a problem is suspected, the TX320 may be checked by measuring the +12 V

and Ground terminal on the CR1000 PC-board wiring panel. Acceptable

readings are +11 to +14 Vdc. Check the SC12 cable connection between the

CR1000 wiring panel and the TX320. Press the TX320 diagnostic button to

query the state of the transmitter. If problems persist, try a substitute. Obtain

an RMA number before returning this equipment to Campbell Scientific for

repair.

Consult the TX320 manual for more information.

NOTE

5.5 CR1000 Keyboard/Display

5.5.1 General Description

The CR1000 Keyboard/Display (pn CR1000KD) shown in FIGURE 5-3 is

used to check datalogger status, to display or plot sensor readings and stored

values, to enter numeric data, or to change port/flag state. The CR1000KD is

powered from the CR1000 printed circuit board “CS I/O” connector via a

standard 9-pin serial cable (pn 10873) that ships with the RAWS.

Use the CR1000KD menus to enter GOES DCP-Setup

Parameters and to select the wind speed/direction sensor on the

RAWS.

NOTE

FIGURE 5-3. CR1000 keyboard/display

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

Campbell-scientific RAWS-P Remote Automated Weather Station Manual de usuario Pagina 26