Campbell-scientific RAWS-P Remote Automated Weather Station Manual de usuario Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
RAWS-P Remote Automated Weather Station
Use the CR1000KD Keyboard
Display to see the “Public
Variables” shown in TABLE 2-1.
NOTE
Connect the CR1000KD Keyboard Display to
the CS I/O connector (FIGURE 5-5) or SC12
Cable (FIGURE 2-1)
Press any key for the CR1000KD Power up
Screen
Press Enter to move down a menu (Press Esc
to move up a menu)
(Press up/down arrow to select item)
Press any key for Power up Screen
Press ^ to turn on/off backlight
Press <> to adjust contrast
Select Data, press Enter
Select Real Time Tables, press Enter
Select Public, press Enter
Press up/down arrow to see the Public Variables listed in TABLE 2-1
TABLE 2-1. Public Variables
Number Name Function
Sensor Variables
1 Batt_Volt System power supply voltage
2 AirTempF HC2S3 air temperature in degrees F
3 RH HC2S3 relative humidity in percent
4 TdewF Dewpoint in degrees F, calculated from HC2S3 data
5 SlrW Solar radiation in watts, pyranometer
6 Rain_in Temporary rain, cleared every scan
7 RainTot TE525 cumulative rain fall in inches
8 WS_mph Wind speed in MPH
9 WindDir Wind direction
10 WSDiag Only for WindSonic data, zero otherwise
11 MaxWS MaxWS, reset 2 minutes before transmit
12 MaxWD Direction of wind during max wind speed
13 SlrMJ Solar radiation in MJoules
14 BP_inHg Hourly — barometric pressure, inHg
15 BPelev_ft Elevation, to correct barometric pressure
16 FuelT_F Hourly — fuel temperature in degrees F
17 FuelM Hourly — fuel moisture, % moisture by weight
GOES Variables
18 CountDwn True or False: True indicates GPS fix good and program is collecting data. False
until GPS fix is obtained
4
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Comentarios a estos manuales

Sin comentarios