Campbell-scientific 03001-L R.M. Young Wind Sentry Set Manual de usuario

03001 R.M. Young Wind Sentry Set03101 R.M. Young Wind Sentry Anemometer03301 R.M. Young Wind Sentry VaneRevision: 8/07Copyright © 1986-2007Campbell S

R.M. Young Wind Sentry 3.4 03101 Anemometer Install the cupwheel to the anemometer shaft using the Allen wrench provided with the sensor. The 03101 m

R.M. Young Wind Sentry Wind Speed Wind Direction 5. Example Programs This section is for users who write their own programs. A datalogger p

R.M. Young Wind Sentry 5.2 Wind Direction The wind vane is coupled to a 10K potentiometer, which has a 5 degree electrical dead band between 355 and

R.M. Young Wind Sentry TABLE 5-3. Wiring for Example Programs Color Description CR1000 CR10X Black Wind Spd. Signal P1 P1 White Wind Spd. Refe

R.M. Young Wind Sentry 'Call Data Tables and Store Data CallTable(Table1) NextScan EndProg 5.4.2 CR10X Example Program ;{CR10X} *Table 1

R.M. Young Wind Sentry 7: If (X<=>F) (P89) 1: 3 X Loc [ WindDir ] 2: 3 >= 3: 360 F 4: 30 Then Do 8: Z=F x 10^n (P30)

R.M. Young Wind Sentry For dataloggers programmed with Edlog (and the CR200), the EX-DEL-SE (P4) measurement instruction should be used. Enter a 2 in

R.M. Young Wind Sentry Symptom: Incorrect wind direction 1. Verify that the Excitation voltage, Range code, multiplier and offset parameters are corr

R.M. Young Wind Sentry This is a blank page. 14

Appendix A. Wind Direction Sensor Orientation A.1 Determining True North and Sensor Orientation Orientation of the wind direction sensor is done aft

Warranty and Assistance The 03001 R.M. YOUNG WIND SENTRY SET, 03101 R.M. YOUNG WIND SENTRY ANEMOMETER, AND 03301 R.M. YOUNG WIND SENTRY VANE are warra

Appendix A. Wind Direction Sensor Orientation Subtract declination from 360° Add declination to 0° 22 E18 E16 E14 E12 E10 E8 E6 E4 E2 E02

Appendix A. Wind Direction Sensor Orientation FIGURE A-3. Declination Angles West of True North Are Added to 0 to Get True North A-3

Appendix A. Wind Direction Sensor Orientation This is a blank page. A-4

Appendix B. Wind Direction Measurement Theory It is not necessary to understand the concepts in this section for the general operation of the 03001 w

Appendix B. Wind Direction Measurement Theory excitation voltage of 2500 mV recommended for the CR10(X) and 5000 mV for an excitation voltage of 5000

R.M. Young Wind Sentry Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat®

This is a blank page.

This is a blank page.

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbells

R.M. Young Wind Sentry Table of Contents Appendices A. Wind Direction Sensor Orientation...A-1 A.1 Determining True North and S

R.M. Young Wind Sentry 1. Introduction The 03001 Wind Sentry Set is used to measure horizontal wind speed and direction. Wind speed is measured with

R.M. Young Wind Sentry The 03301 Vane ships with: (1) 03301 Vane (1) 10” x 3/4” threaded galvanized pipe (P/N 12243) (1) Allen wrench (P/N 5201) 2. S

R.M. Young Wind Sentry The black outer jacket of the cable is Santoprene® rubber. This compound was chosen for its resistance to temperature extremes

R.M. Young Wind Sentry the datalogger has been programmed to measure wind direction as described in Appendix A. Route the sensor cable along the under

R.M. Young Wind Sentry CM220 CM200 Series Crossarm FIGURE 3-3. 03101 Anemometer Mounted to CM200 Series Crossarm with CM220 CM216 FIGURE 3-4. 0300