Campbell-scientific Sentek EasyAG Installation Guide v 3.0 Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 39
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
Removing EasyAG access tubes
Copyright © 1991 – 2003 Sent ek Pt y Lt d All rights reserved Page 34
Removing EasyAG access tubes
Removal of access tubes is a relatively simple process in loose, sandy soils. It may be done
with the electronics in place. Simply excavate some soil from around the probe, then turn the
probe in the soil and pull upwards. In heavier soils, it may be necessary to excavate the soil
around the probe to a greater depth before the probe can be removed by hand.
Alternatively, the access tubes can be extracted with an extraction tool and with a winch, jack,
tractor hydraulics, Sentek extraction tripod or similar. If an extraction tool is used, then the
probe electronics should be removed first.
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39

Comentarios a estos manuales

Sin comentarios