Campbell-scientific CVS4200 / BVS4300 Stationary Samplers Manual de usuario descargar pdf (Pagina 18)

CVS4200 / BVS4300 Stationary Samplers

TABLE 5-1. BVS4300 Component Descriptions

Number Item Description

1 Intake Hose Connection The volume control tube is where the intake hose is connected to

the sampler. This stainless steel tube is raised or lowered

manually using fitting to set the sample volume (see FIGURE

5-3).

2 Multi-Function Input Controller This is where sampler is controlled and programmed.

3 Signal Lights and Control

Switch

The optional top light (green) indicates sampler is running. The

second light (red) indicates reverse polarity if external battery is

being used. The toggle switch turns on/off the controller while

leaving power to the sampler.

4 Metering Chamber This chamber is where the sample liquid is drawn into before

dropping into the final container. The rods inside are raised and

lowered to the sample volume desired.

5 Pinch Valve This valve shuts during sampling, and then releases once desired

liquid has entered the chamber.

6 Instrument Tray Rollers Control section of sampler can be easily rolled out for wiring and

maintenance.

7 Breaker Switches All samplers have an on/off switch. Other options for switches

include fridge and heater.

8 Discharge Tube The sample liquid is released via the pinch valve to the sample

container(s) below. With composite (single container) units the

amount of built-up pressure may cause discharge tube to come

out of the container, so it is advisable to fasten it using the

provided lid.

9 Container Lid The special lid provided fastens the discharge tube to the sample

container. Weight prevents tube dislocation.

10 Sample Container(s) The container(s) that the sample is deposited in can be made

from a variety of materials, shapes, and sizes. In discrete

samplers, there is a distributor arm that deposits samples into

multiple containers.

11 Cabinet Circulation Fan Optional fan for hot weather climates, prolongs the life of

refrigerator. If no fan is present, this space will be solid.

12 Louvers Vents for ensuring proper ventilation in cabinet.

13 Pump Exhaust Connection If the sample fluid is corrosive, the pump exhaust air can be sent

to a separate location through this connector; unnecessary in

most conditions.

14 Instrument Air Connection In corrosive environments, instrument air can be brought in from

another source, prolonging the life of the instrumentation

components. Tubing would be hooked up to the provided

adapter. This is unnecessary in most environments.

15 Instrument Panel Instrumentation is mounted on this panel.

16 Instrumentation Section All instrumentation and wiring, including pump, are located in

this section of the sampler, protected from outside elements.

17 Field Wiring Terminals Terminal block for field wiring is located on the back of the

instrument tray

18 Instrument Tray This tray can be rolled out by unscrewing the four bolts at the top

of the panel, and gliding it out on the rollers.

19 Enclosure Cabinet for entire sampler is powder-coated steel or optional

stainless steel.

20 Mounting Feet Brackets have holes for screwing sampler into a fixed location.

21 Installation Holes Put bolts through these holes into a solid surface to stabilize

sampler.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 91 92

Comentarios a estos manuales

Sin comentarios

Campbell-scientific CVS4200 / BVS4300 Stationary Samplers Manual de usuario Pagina 18

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Campbell-scientific CVS4200 / BVS4300 Stationary Samplers