Campbell-scientific SDM-AO4A Four Channel Analog Output Module Manual de usuario

SDM-AO4A Four Channel Analog Output Module5/11Copyright © 1986-2011Campbell Scientific, Inc.

SDM-AO4A Four Channel Analog Output SDM TransmissionVout 1 Vout 2 Vout 3 Vout 4 FIGURE 3. Sequential Mode 7. Programming The datalogger is programm

SDM-AO4A Four Channel Analog Output 7.1 CRBasic 7.1.1 SDMAO4A Instruction The SDMAO4A instruction is used to set the voltage to an SDM-AO4A. The S

SDM-AO4A Four Channel Analog Output SDMAO4AOption: The SDMAO4AOption parameter is used to set the operating mode for the SDMAO4A. Option Code Descr

SDM-AO4A Four Channel Analog Output Equation for CR800, CR850, and CR1000: bit_rate=INT((k*72)/625)*Resolution Where: k= the value entered in BitPeri

SDM-AO4A Four Channel Analog Output TABLE 4. Description of Instruction 103 Par.No. Data Type Description 01: 2 Reps - Number of analog outputs.

SDM-AO4A Four Channel Analog Output 'Code for DataTable OneMin DataTable(OneMin,1,-1) DataInterval(0,1,Min,0) WindVector (1, WS_ms,WD_0_360, I

SDM-AO4A Four Channel Analog Output 2: Excite-Delay (SE) (P4) 1: 1 Reps 2: 5 2500 mV Slow Range 3: 1 SE Channel 4: 1 Excite all

SDM-AO4A Four Channel Analog Output 10: Sample (P70) ; Sample RH 1: 1 Reps 2: 4 Loc [ RH ] ; Routine to convert 0-360 deg. Dire

SDM-AO4A Four Channel Analog Output 14 22: Z=X*F (P37) 1: 7 X Loc [ TempOut ] 2: 10 F 3: 7 Z Loc [ TempOut ] 23: Z=X*F (P37)

Warranty and Assistance PRODUCTS MANUFACTURED BY CAMPBELL SCIENTIFIC, INC. are warranted by Campbell Scientific, Inc. (“Campbell”) to be free from def

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

SDM-AO4A Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab

SDM-AO4A Four Channel Analog Output 1. Function The SDM-AO4A is designed to output four continuous voltages at levels set by a Campbell Scientific da

SDM-AO4A Four Channel Analog Output 3. Power Supply It is often convenient to power the SDM-AO4A from the datalogger power supply, but when doing so

SDM-AO4A Four Channel Analog Output FIGURE 1. Front Panel of the SDM-AO4A TABLE 1. Description of Terminal Block Connections SDM-AO4A to Datalogger

SDM-AO4A Four Channel Analog Output 5. Addressing The SDM-AO4A is a synchronously addressed datalogger peripheral. Control Ports 1, 2, and 3, are use

SDM-AO4A Four Channel Analog Output FIGURE 2. Synchronous Mode In sequential mode, the channels are set sequentially. The output signal can take fro