Campbell-scientific Sentek EnviroSCAN EasyAG SDI-12 Manual v 3.4 Manual de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 30
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
EnviroSMART & EasyAG SDI-12 Probe Manual
Copyright © 1991 2003 Sentek Pty Ltd All rights reserved Page 10
aD0! a+001.0000+001.1234+000.0200<CR><LF>
aD1! a+000.1234+000.0000+123.1234<CR><LF>
aD2! a+010.1200+000.1243+044.8750<CR><LF>
If there are more than 9 salinity values, a further Start Measurement command (aM! or aMn!) must be
issued.
Command Response
aM3! a0187<CR><LF>
The response indicates that another 7 salinity values will be available within a time of 18 seconds. After
approximately 16 seconds, the probe will issue a Service Request (a<CR><LF>, where a is the probe
address), and the controlling device will then issue Send Data commands (aDn!) to read the values.
Command Response
aD0! a+002.0010+003.1234+001.0200<CR><LF>
aD1! a+011.1234+001.0100+011.3344<CR><LF>
aD2! a+012.0230<CR><LF>
Note: The Send Data commands (aDn!) must be issued in increasing order.
Data Reading using the Start Concurrent Measurement Command (aC! or aCn!)
The following table shows the allocation of sensors for the Start Concurrent Measurement commands
(aC! or aCn!):
aC! Read Soil Moisture values 1 16
aC1! Read Salinity values 1 16
aC2! Reserved
aC3! Reserved
aC4! Read Soil Moisture Configuration values C constants 1 16
aC5! Read Soil Moisture Configuration values B constants 1 16
aC6! Read Soil Moisture Configuration values A constants 1 16
aC7! Reserved
aC8! Read Salinity Sensor Depth values 1 16
aC9! Read Soil Moisture Sensor Depth values 1 16
Note: Start Concurrent Measurement commands (aC! or aCn!) aC2!”, aC2! and “aC7! will result in
a response of “a0000<CR><LF>”.
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Comentarios a estos manuales

Sin comentarios