Campbell-scientific RAWS-H Remote Automated Weather Station Manual de usuario

RAWS-H RemoteAutomated Weather StationRevision: 12/13 Copyright © 2006-2013Campbell Scientific, Inc.

RAWS-H Remote Automated Weather Station • areas where snow drifts occur • low places holding standing water after rains 3.3 Precipitation A rain ga

RAWS-H Remote Automated Weather Station TABLE 4-1. TEMP/RH Connector (color coded orange) Connector Pin Description CR1000 Terminal A Temperature

RAWS-H Remote Automated Weather Station 4.4 Wind Speed and Direction The wind set attaches to the connector labeled WS/WD; this connector is color co

RAWS-H Remote Automated Weather Station TABLE 4-6. FM/FT Connector (color coded brown) Connector Pin Description CR1000 TerminalA CS205 Temperatur

RAWS-H Remote Automated Weather Station The SP10-Handar 10 watt solar panel is recommended for a RAWS where NO communication equipment is used. The S

RAWS-H Remote Automated Weather Station FIGURE 5-1. 12 volt charger/regulator 5.2.2 Wiring The leads from the RAWS connector panel “BATT CHARGER/SO

RAWS-H Remote Automated Weather Station 5.2.3 Troubleshooting If a problem is suspected, the CH100 may be checked by measuring: • input voltage bet

RAWS-H Remote Automated Weather Station 5.4 GOES Transmitter 5.4.1 General Description The High Data Rate GOES transmitter (pn TX320) shown in FIGUR

RAWS-H Remote Automated Weather Station FIGURE 5-2. GOES transmitter 5.4.2 Wiring The TX320 is mounted inside the RAWS environmental enclosure and

RAWS-H Remote Automated Weather Station 5.4.3 Troubleshooting If a problem is suspected, the TX320 may be checked by measuring the +12 V and Ground t

RAWS-H Remote Automated Weather Station 5.5.2 Wiring The CR1000KD connects to the CR1000’s CS I/O connector using the 10873 cable that ships with the

RAWS-H Remote Automated Weather Station 5.6.2 Wiring The CR1000 is mounted inside the RAWS environmental enclosure and fastened to the CR1000 printed

RAWS-H Remote Automated Weather Station 8. References AASC, 1985: The State Climatologist (1985) Publication of the American Association of State Cli

RAWS-H Remote Automated Weather Station in FIGURE 9-3. Note that when a negative number is subtracted from a positive number, the resulting arithmeti

RAWS-H Remote Automated Weather Station FIGURE 9-2. A declination angle east of True North (positive) is subtracted from 360 (0) degrees to find Tru

RAWS-H Remote Automated Weather Station 9.2 USGS Web Calculator The USGS provides an easy way of determining the declination of a specific site. Sin

RAWS-H Remote Automated Weather Station 20

Appendix A. Equipment Wiring and Connector Panel Jumper Location FIGURE A-1. RAWS-H equipment wiring A-1

Appendix A. Equipment Wiring and Connector Panel Jumper Location FIGURE A-2. RAWS-H connector panel schematic 1 of 2 A-2

Appendix A. Equipment Wiring and Connector Panel Jumper Location FIGURE A-3. RAWS-H connector panel schematic 2 of 2 A-3

Warranty “PRODUCTS MANUFACTURED BY CAMPBELL SCIENTIFIC, INC. are warranted by Campbell Scientific, Inc. (“Campbell”) to be free from defects in materi

Appendix A. Equipment Wiring and Connector Panel Jumper Location Page A-2 P22 Jumper 1 to A-4 FIGURE A-4. RAWS-H connector panel jum

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

Assistance Products may not be returned without prior authorization. The following contact information is for US and international customers residing

Table of Contents PDF viewers: These page numbers refer to the printed version of this document. Use the PDF reader bookmarks tab for links to spec

Table of Contents ii 5.6 CR1000 Datalogger ... 14 5.6.1 General Description.

RAWS-H Remote Automated Weather Station 1. Introduction The RAWS-H allows customers who own a Handar Data Collection Platform to upgrade to a Campbe

RAWS-H Remote Automated Weather Station CR1000KD packed in foam (may go here) FIGURE 1-2. Inside environmental enclosure (optional equipment shown)

RAWS-H Remote Automated Weather Station 2. Getting Started Set up and test your station before field deployment. Keep this manual and the CR1000KD Ke