Campbell-scientific CS410 Shaft Encoder Manual de usuario Pagina 1

CS410 Shaft EncoderRevision: 2/09Copyright © 1999-2009Campbell Scientific, Inc.

CS410 Shaft Encoder 6

This is a blank page.

Campbell Scientific Companies Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbells

Warranty and Assistance The CS410 SHAFT ENCODER is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and workmanship under n

CS410 Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for

This is a blank page.

CS410 Shaft Encoder 1. General Shaft encoders monitor fluctuations in water level and the position of water control gates by converting shaft rotatio

CS410 Shaft Encoder 5. Programming The shaft encoder is measured with the PulseCount instruction in CRBasic and Instruction 3 in Edlog. Dataloggers

CS410 Shaft Encoder 'Define Data Tables DataTable (Stage,1,-1) DataInterval (0,15,Min,10) Sample (1,Stage_lvl,FP2) Sample (1,offset,FP2) Mini

CS410 Shaft Encoder 5.2 CR10X Edlog Program Example This program collects and processes data; additional instructions are required to send the data t

CS410 Shaft Encoder 8: Z=X+Y (P33) 1: 1 X Loc [ count_up ] 2: 6 Y Loc [ stage_ft ] 3: 6 Z Loc [ stage_ft ] 9: Z=X-Y (P35) 1: