Campbell-scientific AL200 ALERT2 Encoder, Modulator, and Sensor Interf Manual de usuario descargar pdf (Pagina 32)

Appendix D. AL200 Settings

Hop Limit The maximum number of times a packet, originating from this device, will be

repeated (hop) before being discarded. None (7) disables the limiting of hops.

Example: if this station requires 1 repeater hop to reach the base station receiver, the

hop limit should be set to a minimum of 1.

Path Service Enabled Request that each device that forwards data originating from this station add its

source address to the packet header. Enabling this option allows a receiver to know

the path that the packet took through the network.

Radio Power Up Mode The setting controls when the attached radio is powered up. The radio can be

powered up every frame, continuously, or only when data is available for

transmission. For maximum power savings, set to On Only With Data to Tx. The

radio will only power up if the AL200 has data to be transmitted. For maximum

responsiveness, set to On Every Frame or On Continuously. If On Every Frame,

the radio will be turned on for a minimum of Radio Warm Up milliseconds every

frame.

Radio Warm Up The amount of time power should be applied to the radio prior to the start of the

transmission slot. Power will be applied according to the Radio Power Up Mode.

The value is expressed in milliseconds with a resolution of 10 ms.

Carrier Only Time Amount of unmodulated carrier used in Airlink preamble. The value is expressed in

milliseconds.

AGC Time Amount of tone-modulated carrier used in Airlink preamble. The value is expressed

in milliseconds.

Tail Time Amount of unmodulated carrier to follow transmitted frame. The value is expressed

in milliseconds.

Modulation Voltage This setting controls the modulation voltage. The value is expressed in millivolts,

peak-to-peak. Settings do not take effect until applied.

Modulation Polarity Depending on the radio used the audio AirLink modulation signal may need to be

inverted. For Midland and Ritron radios, set this to Normal.

Last GPS Fix The last time that the device successfully acquired a GPS fix. The time is shown in

UTC. Remember that you may need to correct for your time zone offset when trying

to understand this value in context of the local time.

GPS Power On Interval Time between GPS fix attempts. The value is expressed in minutes.

GPS On Max The maximum time the GPS will remain on while trying to obtain a fix. The value is

expressed in minutes.

Self Report Interval Controls the frequency at which sensor data should be reported, without being

triggered by an event. Value is expressed in seconds.

Sensor Scan Interval Controls the interval at which sensors, with the exception of P1, will be read during

normal operation. Value is expressed in seconds.

SW12 Warm Up Time Controls the amount of time SW12V should be on before reading sensor inputs, with

the exception of P1. A setting of –1 means SW12V will be left on continuously. A

setting of 0 means SW12V will not be enabled before measurement. Value is

expressed in seconds.

P1 Mode Enables the P1 terminal input. The P1 input is most commonly used for measuring

switch closures, like those commonly produced by a tipping bucket rain gage. An

ALERT2 sensor ID of 0 will be used for tipping bucket and general sensor reports for

this input.

D-2

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Comentarios a estos manuales

Sin comentarios

Campbell-scientific AL200 ALERT2 Encoder, Modulator, and Sensor Interf Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Campbell-scientific AL200 ALERT2 Encoder, Modulator, and Sensor Interf