Campbell-scientific SC-USB USB to CS I/O Optically Isolated Interface Manual de usuario descargar pdf (Pagina 22)

SC-USB USB to CS I/O Opto-isolated Interface

The process of installing the drivers should then complete and show this

screen.

Shortly after, a message will normally appear from the device installation icon

in your toolbar as follows:

Take note of the COM port that the SC-USB has been installed as, COM4 in

this case. You need to know this number when setting up the interface in

Campbell Scientific software. Click on close to the two options above to

finish. You are now ready to use the interface.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sin comentarios

Campbell-scientific SC-USB USB to CS I/O Optically Isolated Interface Manual de usuario Pagina 22