Campbell-scientific 014A Met One Wind Speed Sensor Manual de usuario descargar pdf (Pagina 10)

Met One 014A Wind Speed Sensor

4. Quickstart

4.1 Assemble and Mount the Sensor

4.1.1 Tools Required

• 5/64 inch Allen wrench (shipped with the 014A)

• 1/2 inch open end wrench

• compass and declination angle for the site

• small screw driver provided with datalogger

• UV resistant cable ties

• small pair of diagonal-cutting pliers

• 6 inch to 10 inch torpedo level

4.1.2 Assemble the Sensor

The 014A ships with the cup assembly separate from the main housing.

Assemble the sensor using the following procedure:

1. Take the cup assembly and main housing out of the shipping box (see

FIGURE 4-1).

FIGURE 4-1. 014A shipping box

2. Gently slide the cup assembly down over the shaft at the top of the

sensor until it meets the top bearing.

3. Use the 5/64 inch Allen wrench to tighten the screw on the side of the

cup assembly; tighten until snug (see FIGURE 4-2).

Main Housing

Allen Wrench

Cup Assembly

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

Campbell-scientific 014A Met One Wind Speed Sensor Manual de usuario Pagina 10